The 405nm-160mW semiconductor laser is a standardized product of BWT, and BWT has completely independent intellectual property rights for this type of product.
BWT has mature packaging technology and large-scale production capacity, which can ensure the consistency of batch products. With the completion of the Tianjin automated production base in 2021, the production capacity will double, which fully meets the printing industry’s requirements for small size, high brightness and mass production of lasers.
Wavelength: 405nm
Output power: 160mW
Fiber core diameter: 40μm
Optical fiber numerical aperture: 0.22 NA
Laser Direct Writing
Biological Detection
3D Printing
Specifications (25℃) |
Unit |
DS3-11444-K405EMSCN |
||
Optical Data (2) |
Output Power |
W |
12W |
|
Center wavelength |
nm |
405±5 |
||
Spectral width (FWHM) |
nm |
≤6 |
||
Power Range |
% |
10~100 |
||
Fiber Data |
Core diameter |
µm |
400 |
|
Numeric aperture |
- |
0.22 |
||
Fiber output |
- |
Pluggable |
||
Fiber termination |
- |
Pluggable SMA905 |
||
Electrical Data
|
Power supply |
V |
DC 24V |
|
Drive mode |
- |
Constant current |
||
Operation mode |
- |
CW |
||
Control mode |
- |
RS232, I/O |
||
Operation temperature(3) |
℃ |
20~30 |
||
The method of protection |
- |
Over voltage, Over current, Over temperature |
||
Mechanical Parameters |
Dimensions (L×W×H) |
mm3 |
223× 224× 63 |
|
Others |
Cooling method |
- |
Water cooling |
|
Temperature Ambient in Operation |
℃ |
15~30 |
||
Storage temperature (4) |
℃ |
5~50 |
||
Cooling requirement |
- |
Cooling capacity 100W,water flow: 2L/min |
||
Relative Humidity |
% |
5~80 |
(1)Consult BWT for other available options.
(2)Operating temperature defined by the package case. Acceptable operating range is 25℃, but performance may vary.
(3)A non-condensing environment is required for operation and storage.
(4)Operating temperature refers to the bottom plate temperature, the acceptable use of the temperature range of 15 degrees C to 35 degrees C, but the performance may be slightly different at different temperatures.
(5)Laser system appearance size, fiber appearance size, and connection head appearance size, please take the physical, sample picture for reference only.
♦ Avoid eye and skin exposure to direct radiation during operation.
♦ Make sure the fiber output end is properly cleaned before operation of laser. Follow safety protocols to avoid injury when handling and cutting the fiber.
♦ Laser diode must be used according to the specifications.
♦ Temperature Ambient in Operation ranges from 15℃ to 30℃.
♦ Storage temperature ranges from 5℃ to 50℃.