660nm-50mW Red light diode laser is mostly used in medical applications. BWT has been committed to the research and development of lasers for many years, we provided 1,000 medical lasers in batches to American medical customers as early as 2005
The monochromaticity, coherence, directionality, and high brightness of the laser determine its advantages in medical beauty applications. The biothermal effect, photochemical effect, and biostimulation effect mechanism of laser and tissue make laser surgery have the advantage of a small incision, basically no damage to tissue or minimal damage, and less toxic and side effects.
Wavelength:660nm
Output power: 50mW
Fiber core diameter: 9μm
Optical fiber numerical aperture:0.14 NA
Applications:
Dentistry
Surgery
Physiotherapy
Cosmetology
- Please connect pins to wires by solder instead of using socket when operation current is higher than 6A.
- Soldering point should be close to the middle of the pins. Soldering temperature should be lower than 260℃ and time shorter than 10 second.
- Make sure the fiber output end is properly cleaned before operation of laser. Follow safety protocols to avoid injury when handling and cutting the fiber.
- Use constant current power supply to avoid surge current during operation.
Specifications (25°C) | Symbol | Unit | Minimum | Typical | Maximum | |
Optical Data(1) | CW OutputPower | Po | w | 50 | - | - |
Center Wavelength | λc | nm | 660±10 | |||
Spectral Width(FWHM) | △λ | nm | - | 3 | - | |
Wavelength Shift with Temperature | △λ/△T | nm/°C | - | 0.2 | - | |
Electrical Data | Electrical-to-Optical Efficiency | PE | % | 12 | - | - |
Operating Current | Iop | A | - | - | 160 | |
Threshold Current | Ith | A | - | 25 | - | |
Operating Voltage | Vop | V | - | - | 3 | |
Slope Efficiency | η | W/A | - | 0.5 | - | |
Fiber Data | Core Diameter | Dcore | μm | - | 9 | - |
Cladding Diameter | Ddad | μm | - | 125 | - | |
Numeric Aperture | NA | - | - | 0.14 | - | |
Fiber Length | Lf | m | - | 1 | - | |
Fiber Loose Tubing Diameter | - | mm | 0.9mm PVC | |||
Minimum Bending Radius | - | mm | 50 | - | - | |
Fiber Termination | - | - | FC(APC)/SC(APC) /SMA905/ST | |||
Feedback Isolation | Wavelength Range | - | nm | 900-1200 | ||
Isolation | - | dB | - | 30 | - | |
Others | ESD | Vesd | V | - | - | 500 |
Storage Temperature⑵ | Tst | °C | -20 | - | 70 | |
Lead Soldering Temp | Tls | °C | - | - | 260 | |
Lead Soldering Time | t | sec | - | - | 10 | |
Operating Case Temperature(3) | Top | °C | 15 | - | 35 | |
Relative Humidity | RH | % | 15 | - | 75 |
(1) Data measured under operation output at 50mW@25°C.
(2) A non-condensing environment is required for operation and storage.
(3) Operating temperature defined by the package case. Acceptable operating range is 15°C~35°C, but performance may vary.